Micro coil in a Protank V2

Status
Not open for further replies.

john333

Ultra Member
ECF Veteran
Verified Member
Mar 20, 2011
1,658
1,129
Indiana
I use Boge single coil carts in tanks and am happy with them for the most part. I know I give up some flavor especially after a few days use of the cart. So, I have a little experience with rba rebuilds but am far from being an expert. It would seem from reading thru some of the RBA subforum that the micro coil is a method that has eliminated a lot of the issues with coil rebuilds such as hot spots. My question is can I or do you make micro coils for the Protank v2 and if so how is the performance? I need it to be something a can grab and go without having to fiddle around with it. My current setup with carts allow me to do just that. TIA

I am posting this here because the Protank V2 is sold with the Provari Starter Kits now.
 
Last edited:

Vargus

Full Member
Verified Member
Aug 8, 2013
47
12
USA
I use Boge single coil carts in tanks and am happy with them for the most part. I know I give up some flavor especially after a few days use of the cart. So, I have a little experience with RBA rebuilds but am far from being an expert. It would seem from reading thru some of the RBA subforum that the micro coil is a method that has eliminated a lot of the issues with coil rebuilds such as hot spots. My question is can I or do you make micro coils for the Protank v2 and if so how is the performance? I need it to be something a can grab and go without having to fiddle around with it. My current setup with carts allow me to do just that. TIA

I am posting this here because the Protank V2 is sold with the Provari Starter Kits now.

My understanding is that anything that has a replaceable coil can be rebuilt. But I'm not sure if the protank heads have enough room for a microcoil. I believe microcoils require 6 or so wraps.
 

john333

Ultra Member
ECF Veteran
Verified Member
Mar 20, 2011
1,658
1,129
Indiana
This is a video I have been watching. I really like the pro tank 2. It can be done
http://www.e-cigarette-forum.com/fo...-rebuild-tutorial-ss-mesh-ribbon-kanthal.html

I am awaiting my mini in the mail Tuesday according to USPS tracker. I am also receiving an rsst rba so I should be set.

good information. I got a little lost around the 20 minute mark. I couldn't quite see what he was doing. I have to read further on in that thread. I have some 500 mesh but no ribbon kanthal so will have to get some.
 
Status
Not open for further replies.

Users who are viewing this thread