Mini MAP question..

[TJVapes]

I was able to pick up a mini MAP in the classifieds a couple of weeks ago and I love it. Just curious about the fit of the CE2. The CE2 doesn't come up anywhere near the top like I thought it would. I'm not sure how much juice it's suppose to hold, but it only holds about 1 mL and if I tip it a bit it gets in the center tube easily, so I have to be careful not to put anymore than 1 mL. I still love it, just wondering if that's normal. There was no CE2 installed when I received it. I haven't been able to see what they look like yet when purchased new but I should be getting the bigger tank in the mail soon.

 

[spike39]

strange.. the CE2 that I have fits perfectly in the top washer of my mini MAP. I can tip it and lay it down with no leaks. I got nothin'.. <shrug>

 

[Tasteles]

You probably need to push the CE2 up into the tank a little further. It should go up into the top derlin piece to where the bottom of the silicone seal is even with the black derlin.

 

[hairball]

The ce2's fit really tight so you need to work it up until it is flush at the bottom but the battery threads are clearly visible.

 

[TJVapes]

Okay, I'm trying to push it in further it does have space between the washer and battery threads, but I need Heman to get this thing in any further. You know how on the clears there's a clear gasket and then another thready looking metal piece? It won't go past the gasket, so when I put it on the PV you can see the metal ring.. you shouldn't be able to see that outside of the gasket?

 

[VpnDrgn]

Are you trying to use a clearomiser?

You want to use a reg steel CE2 ( no black sticker ), use pipe cutter to cut steel tube off 3/8" from threaded end.
If the fit is really tight you can rub a little Vg on the tube that goes into bottom delrin plug, but very little.
The CE2 should press fit into bottom delrin plug and you should only be able to see threads.

 

[TJVapes]

I am, but I had the same results with the steel. I thought it was how it was designed to be until I started seeing pics online.

 

[spike39]

Just so happens that I have to clean mine tonight. Here's a bad iPhone pic, but I think you can see that it's flush at the bottom. This set-up fits perfectly when placed in the tank and against the top delrin washer. Hope this helps.

 

[TJVapes]

Yea, mine's definitely not in far enough. I'm hoping maybe I can replace the delrin part later but I still need to try more and I don't want to take anything apart right now until I'm ready to change it totally out and also compare with the other tanks that I have now. Thanks for the input guys

 

[Tasteles]

Yea, mine's definitely not in far enough. I'm hoping maybe I can replace the delrin part later but I still need to try more and I don't want to take anything apart right now until I'm ready to change it totally out and also compare with the other tanks that I have now. Thanks for the input guys

You shouldn't need to replace the derlin part unless you damaged it. Just push the CE2 in further until only the threaded end is sticking out.