Modders stuff,what I did with it and cart mod

[Some Guy]

Since I don't own a lathe I was searching for end caps and this is what I found.
MARKSTAAR - Flush End Cap - Product Details

And tube to go with them.
MARKSTAAR - Tubing - Category Details
Polished brass or polished stainless. One inch diameter is minimum on the end caps.
The end caps are very sloppy which worked out good for me as I was able to thread it and add a threaded nylon sleeve between it and the brass tube. It needed the sleeve anyway.

Hopefully some pics of what I made with it and some stuff I did not use yet.


All the parts.


An all day battery needs an all day cart.
Precision dripper


The black parts are plast-dip. It is a improvement (I think) on my plasti-dip cart mod. It works like a precision oiler that many members use to drip or fill carts with. This mod has a removeable rubber stopper with a blunt syringe that rests on or slightly above the atty bridge. And just squeeze the clear plastic area to drip.
Pics hopefully.

 

[mnealtx]

Looks very nice!

 

[Posideon]

looks creepy....
and amazing.
The auto-dripping cart!!

 

[opuscroakus]

Very nice. Wonder if you can get that setup in copper anywhere?

 

[Some Guy]

Thanks all.
Creepy? Now that I think about it I guess it is. Just sharpen the needle and forget PVs altogether.lol
I don't think I saw copper anywhere Opus. The stainless looks nice but I thought I might have trouble threading it by hand.

 

[Archer74]

Very nice! you beat me to it. I had designed a similar one with the same concept. one is the squeeze type and designing another one that will drip a certain amount with each draw your take.