MT3S and Ego C 900 mah twist

[kczar]

I found that my MT3S does not seat properly on the Ego C 900 mah twist. The pin in the battery is fine. I normally use EVOD which I love but those seem to press the pin down. Suggestions?

 

[danny4x4]

1) 510 to 510/ego connector. Would get to you faster if you buy from some place else rather than the link below. Just happened that I had that link on hand.
https://www.fasttech.com/products/0/10003955/1284600-510-to-ego-adapter-convertor-for-e-cigarette

There is another connector that is ego to ego from another site. Would look better on your twist. Unfortunately, I can't remember the site and the item is not widely sold. Most stock 510 to 510/ego.

2) Use a silicon tubing in place of the grommet in the positive pin if you recoil.That way, you can "adjust" how high or low you want the pin to be. There's a thread on ECF about the tubing which you can get on eBay. Search for "burnt grommet fix" or something like that.

 

[GoodahSP]

1) 510 to 510/ego connector. Would get to you faster if you buy from some place else rather than the link below. Just happened that I had that link on hand.
https://www.fasttech.com/products/0/10003955/1284600-510-to-ego-adapter-convertor-for-e-cigarette

There is another connector that is ego to ego from another site. Would look better on your twist. Unfortunately, I can't remember the site and the item is not widely sold. Most stock 510 to 510/ego.

2) Use a silicon tubing in place of the grommet in the positive pin if you recoil.That way, you can "adjust" how high or low you want the pin to be. There's a thread on ECF about the tubing which you can get on eBay. Search for "burnt grommet fix" or something like that.

I'm thinking danny4x4 means this adapter linked below

eGo to eGo Sealed Adapter - Kidney Puncher

 

[danny4x4]

Ahhh! That the one. Thank GoodashP, you're good.