Not sure of price yet (these are fairly expensive) but we requested and will also have coil and wicks, individually packaged, from the manufacturer, in four ohm choices: 1.7, 2.5, 3.0 and 5.0 ohms...
- Status
I'll be in charge of cleaning and filling Phoenix's
I'll tip really well for that service, since I had so much trouble with the BC variety...
Edit: that should read TC
Last edited:
I'll be in charge of cleaning and filling Phoenix's
Haha, good! As much as I like those Phoenix BC's they sure do need filled a lot!
How do you fill those SGV3 lookalikes? Didn't see a fill hole...
Sent from my MB855 using Tapatalk 2
Sent from my MB855 using Tapatalk 2
how much?????
i just got a bulli t clone from poland for 20 quid(that but 30 usd i think) these mass factory produced rebuildable are gonna be nowhere near price of homemade modded ones
i just got a bulli t clone from poland for 20 quid(that but 30 usd i think) these mass factory produced rebuildable are gonna be nowhere near price of homemade modded ones
Can someone tell me about the advantages of the SRT, please? Everyone is so excited about it, and I must say, I wasn't going to get one, but now I'm curious. (big surprise there... not)
No, these will be priced a bit more than the Nova but nowhere near 50-60...we will also have coil/wick packages from the manufacturer (this was soemthign we asked for and they are providing for us) available for good prices in individual packs in four ohm levels. But of course you can use your own from whatever other source you may have. The coil and wick assemblies will be extremely easy to change out and we are also looking at getting the smaller screw drivers best used to change out everything from same manufacturer.
Last edited:
With a fully rebuildable system, you have reduced the cost of vaping to mear Kanthal wire, wick & juice.
This is the most cost effective way to vape, by far, hands down...
Of course, rebuilding atty's won't appeal to everyone, but for those of us who are shall we say, "Frugal", it will be the Bomb. Previously, these rebuildable's where only avail from a few select modders, at very high prices, and VERY hard to get.
Last edited:
Thanks.
Can you adjust the quality of the vape by tinkering with how you rebuild the coil? Like, do people fine-tune it, or play with wick materials, etc.? I keep hearing about things like that - does this setup make it easier?
Can you adjust the quality of the vape by tinkering with how you rebuild the coil? Like, do people fine-tune it, or play with wick materials, etc.? I keep hearing about things like that - does this setup make it easier?
From the looks of this it could easily be modified to use a genesis style wick and coil.
I do have one question is this going to be all metal seem obvious it would be but want to know for sure.
Question is about the hypermiser.
I do have one question is this going to be all metal seem obvious it would be but want to know for sure.
Question is about the hypermiser.
Last edited:
To me it seems ridiculous how expensive and hard to get the true rebuildable atomizer tanks are. I will be getting a hypermizer for sure.
- Status