So my contact pin on my V2 will loosen, but it will only tighten up about 75% of the way, still wroks, no issue, but now it won't sit flush on my devices without an adjustable pin... So does anyone know where I can get a replacement? I don't want to send it in to get fixed, I just want to try and find a replacement piece. Thanks
RDA Mutation X V2 Contact Pin Issue
- Thread starter chav
- Start date
- th_trl_thread_readers 0
- Status
Are you referring to the 510 pin / screw on the bottom that makes positive contact with the battery? I think you want to just snug it down and not "crank on it"..... reason I say that is it looks like that pin/screw holds the center connector in place.... if that pin/screw is torqued down too tight the insulator may be damaged.
I hope I'm talking about the same thing you referred to.....
From what the vendor told me that 510 screw is not adjustable. It does hold the positive block in position and by loosening the pin it allows the block to turn. I have been able to get away with a little loosening the screw/pin a little after installing coils, but it's most likely not good or safe practice. If the positive block moved enough a dead short might result and that's not good......
- Status
