mutation x v2....

[Stinkytofus]

cant believe they came with nonphilip screws... u have to use the screwdriver they provided in the box...

 

[jayblizzo187bx]

Yea, it's a bit obnoxious. Could have done allen keys, torx heads or anything else but no. How about a triangle.

 

[inswva]

You could always replace the supplied fasteners.

 

[Froth]

It's almost physically impossible to strip a triangle drive, so I'm assuming that is why they're using them.

HOW DARE THEY CHANGE THE SCREW HEADS TO A BETTER DESIGN AND THEN INCLUDE THE TOOL TO TIGHTEN THEM!! THE AUDACITY!!

Seriously? SERIOUSLY!? Come on, they changed the bit drive and give you the included tool and you STILL whine!? Some people can never be happy...

 

[greyknight]

Just as an aside, I noticed the cheap bit set I got from harbor freight included the triangle drive bits. Best $7 I ever spent! Haven't run into a screw I can't handle yet.

 

[Wraith504]

i like the flush triangles myself. and since you have a positive t post its pretty easy to work on one side tighten her up then work the other side. not like singles where you have to manage to keep both coils on your mandrel while tightening.

 

[jaxgator]

Initially, I .....ed about the triangle heads. Now? Not so much. Been using it for about 2 weeks now without issue. Great rda!

And yeah wraith, posi t-post was worth it itself to pay for the upgrade from the v1 imo.

 

[Wraith504]

Yea, it really seems like they covered most of the bases. Lots of air, single coil option, t post, silver contact, deep well. huge bore tip, I dont like the fact that the tip isnt 510. Thats about the only complaint i have so far.

 

[jaxgator]

Funny you should say that about the drip tip mounting hole Wraith. I too, .....ed about that initially. However, I'm kind of happy with it now after use. It's not chuff size (too much for me) but it's not 510 either (not enough). It's just, umm, did I just walk into a Goldilocks story here?

I guess I've just come to enjoy the draw I get from it. 24g kanthal, appox 2mm mandrel, 3/4 wraps (.18Ω) with full rayon wick (no hair dresser here ). afc half way open. 2-3 sec lung pulls. Works for me.

I drop 20 drops in this. 5 on each wick side without any leakage and long, long vape sessions.

 

[minusbacon]

It's almost physically impossible to strip a triangle drive, so I'm assuming that is why they're using them.

HOW DARE THEY CHANGE THE SCREW HEADS TO A BETTER DESIGN AND THEN INCLUDE THE TOOL TO TIGHTEN THEM!! THE AUDACITY!!

Seriously? SERIOUSLY!? Come on, they changed the bit drive and give you the included tool and you STILL whine!? Some people can never be happy...

The tip of the included tool has broke on me. Twice. After the first break I could still use it but now that it broke again I can't use it at all. I really don't wanna buy another tool set just for one dripper.

Has anyone found replacement screws for this yet?

 

[Wraith504]

The tip of the included tool has broke on me. Twice. After the first break I could still use it but now that it broke again I can't use it at all. I really don't wanna buy another tool set just for one dripper.

Has anyone found replacement screws for this yet?

have you tried the screws from the v1? if you have one.