MVP 2.0 and vivi nova

[LynnNC]

For the umpteenth time, when I put my T3S on my mvp after using the vivi nova on it, I have to take a screwdriver and pull up the center pin for the T3S to work. What can I do to stop this other than not using the vivi nova on it? I'm afraid that if I keep doing it I'll break the pin on the mvp.

 

[classwife]

Moved from Simple Solutions to Variable Voltage APV Discussion



Simple Solutions is to assist the Beginning Vaper

 

[LynnNC]

Thanks! I didn't know where to put it.

 

[Nomoreash]

Most full proof solution is to get a 510/510 shorty adapter for your vivi nova and use that with it, that way it won't be pushing the center pin down. You may not want the raised look but it'll work.

Easiest solution is not screw your Vivi on so far, all it needs to do is make contact with the center pin, anymore than that and it'll push it down. It may not sit flush but as soon as it makes contact just make sure it's secure and leave it.

Another option is to file the center pin on the Vivi down a little bit. I did that with mine when I was using them.

 

[herb]

Pry the pin up on the MVP until you can see the lip , now slip a #60 size o ring around the lip and you will never have that issue again , works fantastic . Those o ring sizes come in a small little plastic tub which can be found at any Home Depot or hardware store.

 

[LynnNC]

Thanks! I'll try one or both of these suggestions!

 

[gerrymi]

Fixing The MVP/VV3 Contact Issues - a guide

http://www.e-cigarette-forum.com/forum/blogs/capt-shay/6338-fixing-mvp-vv3-contact-issues-guide.html

 

[LynnNC]

Fixing The MVP/VV3 Contact Issues - a guide

http://www.e-cigarette-forum.com/forum/blogs/capt-shay/6338-fixing-mvp-vv3-contact-issues-guide.html

Thanks!! I'M already doing the one with the screwdriver.