Yesterday I bought a new Kanger T3S to use on my mvp2.0 and it worked great. I wanted to try a different flavor so I put a vision vivi nova on the mvp and used the t3s on a vision spinner. Today, however, I put the t3s back on the mvp and it won't work. The mvp keeps giving me the non message. What did I do wrong? Also, the vivi nova reached a place where I could get very little air flow and it's like sucking through a closed up straw. Solutions to my problems?
MVP 2.0 and Kanger T3S
- Thread starter LynnNC
- Start date
- th_trl_thread_readers 0
- Status
The MVP has a very deep 510 connection, since you threaded the Vivi, it pushed the center pin further in. With a small screwdriver, lightly pull the pin up.
SCREW THINGS IN LIGHTLY! TOO MUCH PIN PULLING CAN RENDER THE MVP USELESS!!!
SCREW THINGS IN LIGHTLY! TOO MUCH PIN PULLING CAN RENDER THE MVP USELESS!!!
- Status
Similar threads
