mvp 2.0 every tank I put on...

[dannijustdanni]

So I got 2 mvp 2.0s for my husband and I. After 3 weeks, every single tank I put on either of them is gurgling. We each have the iclear 30 That came with them, an aerotank and a unitank. No matter what, they're all gurgling. 6 tanks on 2 devices. I tried the "pry the center pin up a tiny bit" fix, and there's no way i pryed it too much as terrified as i am about breaking it. Help!

 

[williamclarkonet]

I would turn the volts or watts up they maybe to low to propley "burn" the juice or the e-juice is too much pg and not enough vg

 

[Frenchfry1942]

If I get a bit of gurgling, I fire the MOD a few times without taking draws. It, basically, burns the juice at the coil but doesn't pull more juice very well. Depends on the topper, but is a thing that I try.

 

[DingerCPA]

I've sparingly used the iClear 30 (I don't care for top coils), and I don't have the Aero- or Unitanks, but I have a bunch of PT2s. Make sure your tanks are snug, but not over-tight. Check your o-rings (1 - that they're even there or 2 - that they're not pinched, damaged, torn.)

+1 on nudging up voltage/wattage. Are you drawing too hard? You might be pulling more juice than the coil can vaporize. Also, how fresh are the coils? If they're gunked, you'll have trouble vaporizing the juice.

On the Aero or Unitanks, you might try blowing from the base out the mouthpiece. If there's excessive juice in the chimney, that can cause some gurgling. You might try changing up the airflow on those (at least on the Aero.) It looks like the Unitank is top-fill - could you have gotten juice in that chimney?

I'm just trying to throw out suggestions (which may not even be worth the paper on which they're written )

Good luck! Hopefully someone has some sage advice for you.