MVS Giveaway thread !!!
- Thread starter aasupplyny
- Start date
- th_trl_thread_readers 0
- Status
Hi dan and doing great!!
Hope you are too.
well they shut my internet off at work by blocking all non office things with some iprism thing....but seems i should be in computers cause i found a way to get around it...at least for now lol... so i am good
Hello everyone! Made it through the week, and now looking forward to a 4 day holiday weekend!
Oh, I'm sorry about that. That's no fun. I work at a non-profit, and the benefits are that we get Xmas eve & New Year's eve (as well as Xmas day & New Year's day) off as compensation for our low salaries
.
Well one more post..
I do stuff for the church and senior senior citizens around here and I don't get paid for it at all so, yes, love is involved.
Now good night for sure this time.
I do stuff for the church and senior senior citizens around here and I don't get paid for it at all so, yes, love is involved.
Now good night for sure this time.
So, I'd been waiting on some Kanthal from before I tested out the rba you were kind enough to send my way aasupplyny, and that arrived yesterday. The RBA is working great so far, thanks for being awesome enough to give these out in a drawing!!
I built a nice 4/5 coil using 30g Kanthal and SS, measured out to 1.2ohms, and it's hitting pretty decently with my Vamo so far! I think I'm going to have to either sand down the cap a little bit, or remove the top o-ring though, because the air hole isn't lining up with the wick at all and the threading on the upper half of the RBA is too small to loosen the cap to adjust. No complaints from me though, that's part of having RBA's, so you can mod them to suit your own likes and dislikes, and I like having options like that anyway!
Thanks again for being able to share so many of these with us! How's everyone elses coming along, anyone get theirs built and tested yet?
I built a nice 4/5 coil using 30g Kanthal and SS, measured out to 1.2ohms, and it's hitting pretty decently with my Vamo so far! I think I'm going to have to either sand down the cap a little bit, or remove the top o-ring though, because the air hole isn't lining up with the wick at all and the threading on the upper half of the RBA is too small to loosen the cap to adjust. No complaints from me though, that's part of having RBA's, so you can mod them to suit your own likes and dislikes, and I like having options like that anyway!
Thanks again for being able to share so many of these with us! How's everyone elses coming along, anyone get theirs built and tested yet?
i have mine setup with 30g 6 coils comes in at 2.2 ohms.. works great but damn the batteries drain super quick compared to the ce4 2.6 ohm clearomizers i use.. Im guessing its from the ss wick.
i dont know i run both low and high ce4's on it and they dont drain it like this does.. i know its only a icr18350 900mah but wow i can watch the bars drop like 5 to 10 drags a bar..
Which causes battery drain quicker, lower ohms or higher watts/volts, or is it about the same considering which you have low/high?
- Status
