My Buttons are Having issues

[JD408]

Unfortunately the 2 chucks I bought a short time ago have button issues.
Takes a lot of button pushing to get activation now.
I rely on these units quite a bit and dont use anything else other than 5v passthroughs at times.
Is there a way for me to fix/replace these buttons myself without sending it back?
I dont know if if there are instructions or somekind of walkthrough anywhere, but Im interested in trying to fix this myself so I dont have to be without my units.

 

[dwillings]

I had the same issue when I first received my chuck but in my case I discovered if I pressed the switch down firmly and waited 2-3 seconds until I heard the sizzle of the atomizer heating up, i could then take a drag and it worked perfectly fine. I did this for a couple of weeks and eventually it kind of fixed itself (oddly enough). Now the switch works perfectly fine. Maybe it takes a while to break it in?

 

[JD408]

actually it worked fine for a while when I first got them, but now they are having issues. My Big chuck is the worst. I actuall yahve to try to apply pressure in an upward or downward side motion and in at the same time to get that one to activate now.
They for sure either need some kind of adjustment, or replacement

 

[AmyB66]

I had the same issue when I first received my chuck but in my case I discovered if I pressed the switch down firmly and waited 2-3 seconds until I heard the sizzle of the atomizer heating up, i could then take a drag and it worked perfectly fine. I did this for a couple of weeks and eventually it kind of fixed itself (oddly enough). Now the switch works perfectly fine. Maybe it takes a while to break it in?

Same for me. I did have one that didn't just fix itself but I gently wiped the button down with a slightly damp qtip and rubbing alcohol. Did not soak it cause I think that might break it but it seemed to help alot.