. Parallels on a dual coil. Should make for a lot of cloud. I agree about the clapton thin myself as well. Some attys just really prefer them though. I’ve got a solomon2 (currently in pieces for gasket replacement) that had an odd side mounted deck that just wasn’t very large. The only way I could get enough wire into it was to use a fused clapton
Be very cautious with builds below .2ohm. The problem is small form factor ohm meters, while they claim to be accurate to a hundredth of an ohm actually aren’t. It’s more like a tenth of an ohm. As a result you could have a coil that reads .13 but could in reality be as little as half that.Update to favorite build. Tried the same thing in 24 gauge. 5 wraps comes out at .13 t .15 for dual coils. I may have a new Fave!
Sent from my SM-G892A using Tapatalk
Steam engine came up with the same resistance. I run all my builds through steam engine before they are built. So far the resistance my mod says has been pretty close to what steam engine says it should be. I have been vaping these builds for a couple of weeks now, all good!
Like I said, use caution. You are quite close to dangerous levels of resistance and equipment accuracy is limited. I personally find “I haven’t blown my face off yet” to be a somewhat limited argument.
Understand where you are coming from, I vape mostly on a regulated mod and my mech squonker, all builds go on the regulated first. If all good then I will throw it in my squonker. And I still have my face
Update to favorite build. Tried the same thing in 24 gauge. 5 wraps comes out at .13 t .15 for dual coils. I may have a new Fave!
Sent from my SM-G892A using Tapatalk
