My first mech mods (the natural and RSST). Gap problem

[azncaboiz]

Hi all.
I'm a newbie in this forum. I glad I switched to e cig 8 days from today. Since then, I haven't smoked a cigarette. At first, I started out with the Ego Ctwist. After having it for 2 days, I got myseft a Vamo. After having the Vamo for 4 days, I went out and got myself a first set of mech mod and rba (The Natural and RSST). I guess I'm a kind of person like to upgrade thing rapidly. Albeit it costs quite a bit but I think it's great investment to stop going back to analog.

However, my Natural have slight problem on the fitting with the RSST. If has the small gap between the mod and the rba.
Anyone who owns this set please show me how to fix this problem so the mod and Rsst fit flush. Thanks

 

[Heavyrocker]

The top cap has a pin that can be backed off,but then the gap ends up being on the Mod body,i heard you can sand down the top of the Natural a tad.

 

[azncaboiz]

Could anyone please let me know where I can purchase just the top cap only for RSST. I accidently drilled the air-hole to almost 2mm and now all I get is air, not much vapor, really loose draw. I've seen someone post in RSST thread where to purchase the tank but not the top cap. Thanks much!!!

 

[StarDose]

2mm would still work fine you may just need to work on your coil and wick. Also did you screw your rsst on before adjusting your battery if its telescopic. Haven't had a natural but I know telescopic mech mods sometimes push the pin up when you tighten the battery in place so best to put the tank on first.

 

[Crash Moses]

Hi all.
I'm a newbie in this forum. I glad I switched to e cig 8 days from today. Since then, I haven't smoked a cigarette. At first, I started out with the Ego Ctwist. After having it for 2 days, I got myseft a Vamo. After having the Vamo for 4 days, I went out and got myself a first set of mech mod and RBA (The Natural and RSST). I guess I'm a kind of person like to upgrade thing rapidly. Albeit it costs quite a bit but I think it's great investment to stop going back to analog.

However, my Natural have slight problem on the fitting with the RSST. If has the small gap between the mod and the RBA. View attachment 217934
Anyone who owns this set please show me how to fix this problem so the mod and Rsst fit flush. Thanks

The screw on the top of the RSST raises and lowers the center pin. Take the cap off and turn the screw until the RSST sits flush with the Natural (you'll need to screw the RSST down while doing this). Be careful not to back it up too far or the center pin will lose connection with your mod.

The top screw on the RSST is fiddly. I have to make routine adjustments to it.

 

[azncaboiz]

I think I need to rework on the wick and coil. Thanks