My pod system trouble

[DavidDewar]

I recently switched from juul to mylé and it was much better until recently I accidentally refilled a pod and forgot to put the cap on when I put it back, after a few minutes I realised what I did so I took it off and replaced the cap, I then used a q-tip to clean out the mylé and when I put the pod back in it was detecting it but the lights wouldn't go on when I tried to drag and nothing happened. I'm not sure if I completely wrecked it or if I just need to dry it out? And if anyone can let me know if there's a way to take the battery out like with a juul that might help, since it doesn't look like it does open the same way. I cleaned absolutely all of the juice from the pod chamber that I can get, but it still doesn't work.

 

[dansus]

I'm not sure if I completely wrecked it or if I just need to dry it out?

The switch has probably got wet, let it dry out somewhere warm and it might come back to life.

 

[stols001]

Disassemble it as much as you can, leave it in front of a fan (if you have one) and wait. It may or may not return to life, but sometimes these things can surprise you. I dropped a Tarot Mini into a cup of coffee (large cup, small mod) and I just wiped it down with rubbing alcohol and let it dry a few days.

If there are any areas you can swab/wipe down with rubbing or isopropyl alcohol, it may be worth doing, but gently and not too much, as you are dealing with an eliquid flood, and sometimes even a very thin coating of eliquid can cause the mod to not function correctly so you want to get as much off/out of the mod as you can.

Good luck, I'm thinking you sort of have a 50/50 shot on this one and good luck!

Anna

 

[spaceman84]

Try carb cleaner. I have a feeling that the air flow sensor is covered in juice. Flushing with isopropyl alcohol could work but will take longer to evaporate. Carb cleaner will blast it out and leave everything nice and clean.