My Setup Today

Status
Not open for further replies.

AdamAnd

Super Member
ECF Veteran
Apr 20, 2011
956
1,233
Ajax, Canada
Todays setup.jpg32 Gauge Kanthal 3 wires twisted great flavor and vapor , Kanthal A1 flat wire great flavor 2mm Silica wick because that's all I have. Works Great ohms out at .7 but in the future will try to get the resistance of each wire closer together oops :unsure: In my Ithaka on my just GG. ;)
 

AdamAnd

Super Member
ECF Veteran
Apr 20, 2011
956
1,233
Ajax, Canada
Here is my build for Flavor today use this setup to test new juice three twisted 32 Kanthol micro coil on a 8 dollar dripper on a GG stealth 3.7v imr 16340 550mah bat ohm's out at .8 cotton wick s pattern. Just put the wick underneath not through the coil works great imo.
 

Attachments

  • 20140129_071230.jpg
    20140129_071230.jpg
    16.4 KB · Views: 20
Last edited:

AdamAnd

Super Member
ECF Veteran
Apr 20, 2011
956
1,233
Ajax, Canada
20140130_090217.jpgTodays setup one .4X.1mm Kanthal wire .9 ohms and one 4X.1mm Kanthal wire twisted with a 34 kanthal wire that wasn't being used for anything .9 ohm's Recycle, Reuse Hoping the ribbon wire will produce lots of vapor and the twisted wire will give me some heat and flavor. should be .45 ohms and at 3.7v I should get 8.2 amps 30 watts but the resistance is always just a bit higher when I build it will see what happens.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread