Hi,
This is how I prepare my genesis wick (in case it can help somebody)
First cut your piece of mesh and boil it for 3- 5 min.
1 divide the width of the mesh in 2 pieces ( aprox. 1/3 and 2/3)
2.take the bigger piece and roll it very tight (no need for a needle central hole).
3.take the smaller piece and blow torch it orange unrolled (Jack Frost method)
4.roll the oxidized piece over the first unoxidized piece
5.blow torch orange only once for 5- 10 sec the wick obtained on point 4 and let it cool in the air.
6.put some e-juice on it and burn it with a lighter (2-3 times)
All the process takes less than 10 min.
Now you can make the coil.
Since I make the wick like this never had a hot spot, or wicking problems.
This is how I prepare my genesis wick (in case it can help somebody)
First cut your piece of mesh and boil it for 3- 5 min.
1 divide the width of the mesh in 2 pieces ( aprox. 1/3 and 2/3)
2.take the bigger piece and roll it very tight (no need for a needle central hole).
3.take the smaller piece and blow torch it orange unrolled (Jack Frost method)
4.roll the oxidized piece over the first unoxidized piece
5.blow torch orange only once for 5- 10 sec the wick obtained on point 4 and let it cool in the air.
6.put some e-juice on it and burn it with a lighter (2-3 times)
All the process takes less than 10 min.
Now you can make the coil.
Since I make the wick like this never had a hot spot, or wicking problems.