Ive cleaned all the copper as said to do in other reviews and its still mot fixing the issue. I had the trigger pressed on accident until the battery died rigjt before this issue arrised. I replaced the battery and coils as well. Yet its still not firing. I have fiddled with the settings so the battery doesnt shake as well as allowing the battery some room. Im using a mutilator v3.
My tesla steampunk wont fire.
- Thread starter Chad timmer
- Start date
- th_trl_thread_readers 0
- Status
Do you have an ohm reader? If so, use that to check for continuity in the atomizer. It is possible that the atomizer has failed due to excessive heat. This can lead to one of a couple things. The first is the insulator melting and it giving a dead short(very bad news). The other is that it may not make any connection at all, and therefore cannot fire. Hopefully this is what happened.
Long story short, check the atomizer on an ohms reader. If possible, try with another atomizer. If you only have one atomizer and it checks out good on the ohms reader, try that atomizer on another mod(preferably regulated with short circuit protection) if you have one just to test it. If the atomizer reads no continuity on the ohms reader, your atomizer is probably toast.
Long story short, check the atomizer on an ohms reader. If possible, try with another atomizer. If you only have one atomizer and it checks out good on the ohms reader, try that atomizer on another mod(preferably regulated with short circuit protection) if you have one just to test it. If the atomizer reads no continuity on the ohms reader, your atomizer is probably toast.
+1 above....if I'm understanding your post correctly, that you've got a new battery and all your connections are clean/dry/adjusted...then the above's really all it can be...
- Status
Similar threads
