MyFeedomSmokes DIY Flavoring Percentage?

[Gonzo562]

Just bought some DIY flavoring from MFS. Bought Dunhill and Marbro. What percentage is good for these flavors? I was thinking 20-25% flavoring would be good but the less i can use the better. I'd be able to make more bottles. FIY I'd like to have a full rich flavor. I know i can start with less and just add more to my liking but though someone would have an answer.

 

[mwa102464]

The best for DIY is really whatever your taste buds tell you is the best ! I would think your in a good range if that's all your doing is just using it for that one flavor and nothing else. I use a Maxboro but as a base in some of my mixes along with other flavors and it works well, but really it all comes down to whatever you really like most. I would make 3 small bottles (3ml each) and go 15% in one 20% in the next and 25% in the 3rd use one of them each day and right down your findings. A lot of people DIY and forget to make notes, this is a very important factor & make sure you save your ecalc mix in a file with notes.

 

[MacDiver]

I agree with mwa. Start at 15 and go up if needed. On the DYI pages that is what is recommended too but tobacco flavors could be a different animal. I don't use tobacco flavors myself so I'm no help there. However, 25% does seem too strong to start with.

Best of luck!

 

[Mayasveil]

Just bought some DIY flavoring from MFS. Bought Dunhill and Marbro. What percentage is good for these flavors? I was thinking 20-25% flavoring would be good but the less i can use the better. I'd be able to make more bottles. FIY I'd like to have a full rich flavor. I know i can start with less and just add more to my liking but though someone would have an answer.

you may wanna check, but MFS does not sell flavoring .

 

[Freedom]

That is correct...What you purchased was vape ready liquid.