Nautilus coil legs

[r77r7r]

Anyone have a photo as to where the legs of the coil go on a stock setup? YouTube vids are pretty lousy! TY much!

 

[smacuser]

Does this help?

Thanks for the new avatar r7.

 

[Breezy Dawn]

I just did my first nautilus yesterday and im pretty happy! Its not a perfect draw but it works and im bound to get better. I used rip trippers video except feed the coil threw the top instead of bottom.

 

[r77r7r]

Great, ty both. Now, does the wire in the grommet go inside the post? Or between the post and grommet? That's where I'm lost. It'd be too loose inside it??

 

[r77r7r]

Does this help?

Thanks for the new avatar r7.

Steal and share my avatar please - I did

 

[Breezy Dawn]

When putting the gromet,first leg to the outside,then 1 leg inside gromet held by the pin that goes in last. Look at the pic you will see them

 

[r77r7r]

Here it is trapped between the pin and grommet. Guess that's correct, ty. The hole inside the pin made me think it'd go inside.

 

[r77r7r]

I just did my first nautilus yesterday and im pretty happy! Its not a perfect draw but it works and im bound to get better. I used rip trippers video except feed the coil threw the top instead of bottom.

You're awesome that you can do that. I've read where experienced coilers couldn't! Better a tight draw than bad leak, it seems?

 

[Breezy Dawn]

You're awesome that you can do that. I've read where experienced coilers couldn't! Better a tight draw than bad leak, it seems?

It was the first time i ever rebuilt a coil,any coil ever! I only built on a rba a few times but think for me its time to get it right. I think for mine i used a bit too much cotton,its tight and gurgles a little. Still i see its going to be a great money saver and it will get better.

 

[Breezy Dawn]

I watched this over and over again,lol but this is what i did,except i put the coil in through the top instead of the bottom.

 

[WharfRat1976]

Clip the leads super short. When you do your screwdown you have to make sure the leads do not rub on the coil head housing. If they do they will distort your freshly wicked coil. Do not overtighten either.