Hello people's,
I have a genuine velocity v2. I bought some notch coils to try out. Installed them fine and wicked at 0.16ohms. Using either the Wismec dna 200 and Wismec rx200. I put both them in temp mode for SS and locked the ohms. Set temp to 420F and the performance is not there. It's not firing properly on either one. On the rx it's not even staying in temp mode and keep going back to wattage mode. Dna200 seems to detect the ohms at 0.09ohm even after I lock it to 0.16ohms before vaping.
I tried wattage mode but keep getting burnt hits on both.
I am obviously missing something. Can someone guide on what I should be doing? Happy to go with wattage of temp mode. Also in temp mode I noticed I was still getting dry hits...so something is obviously not right.
Sent from my iPhone using Tapatalk
I have a genuine velocity v2. I bought some notch coils to try out. Installed them fine and wicked at 0.16ohms. Using either the Wismec dna 200 and Wismec rx200. I put both them in temp mode for SS and locked the ohms. Set temp to 420F and the performance is not there. It's not firing properly on either one. On the rx it's not even staying in temp mode and keep going back to wattage mode. Dna200 seems to detect the ohms at 0.09ohm even after I lock it to 0.16ohms before vaping.
I tried wattage mode but keep getting burnt hits on both.
I am obviously missing something. Can someone guide on what I should be doing? Happy to go with wattage of temp mode. Also in temp mode I noticed I was still getting dry hits...so something is obviously not right.
Sent from my iPhone using Tapatalk