Need advice

[Andre Hamraee]

hello. I have a itaste MVP 2.0 and i am looking at getting a Trident clone V2 rebuildable. I was wondering what the best voltage and wattage for a 0.6-1.5 ohm reading would be on the itaste MVP. The voltage goes from 3.3-5.0 and the watts go from 6.0-11.0. hope to hear back. thanks

 

[fuelfiredesire]

The MVP has a 5 amp switch
so 1.5 ohm is about as low as it goes
Run it at the full 5 volts for the best vapor production.
Sent from my RM-917_nam_usa_214 using Tapatalk

 

[prairie guy]

i agree with fuel. I think you can run down to around 1.0- 1.2 ohm on the mvp. keep it above that and use the wattage to find the sweet spot

 

[Andre Hamraee]

where is the switch?

 

[p7willm]

First you need to decide if you want vapor or flavor. Then, expecially if you want flavor, you need to try it out yourself. Taste is a very personal thing and what one person likes another will not like. Different juices also can taste different at different wattage. Some might taste better at a lower wattage than others.


Google MVP and find the manual in several places.

 

[Baditude]

where is the switch?

What they really meant to say was most all regulated mods like your MVP have pre-determined amp limits and protected circuitry to prevent the mod from firing a coil less than 1.2 ohms or so. The processor see's any atomizer less than 1.0 ohm as a short circuit and will refuse to fire it to protect itself.

As others have said, you can build a single coil on an rba around 1.2 ohms or higher. To be able to sub-ohm, you will need either a mechanical mod (no protective circuitry) or a dna regulated mod.

 

[Topwater Elvis]

The MVP 2 has a 3 amp limit.

 

[Andre Hamraee]

baditude, so if i get the trident clone V2 and i do a single coil, will i still get the plumes of vapor?