Need help. Please!

[Jimmychicken69]

I got a new k tech mini sub box and tank. It came with 3 atomizers. I put it all together and it says "atomizer low" I don't know what to do. I'm mad cause I waited 3 weeks for it to come in and it doesn't work

 

[nineironman]

I got a new k tech mini sub box and tank. It came with 3 atomizers. I put it all together and it says "atomizer low" I don't know what to do. I'm mad cause I waited 3 weeks for it to come in and it doesn't work

Check your resistance, it may be too low to be fired, did you build your own coils? Check your ohms bro.

 

[BrotherBob]

Welcome and glad you joined.
Might like to read:
Beginner | Guide To Vaping
ECigarette Academy: Essential Need to Know for New Vapers
One Stop Reference Shop For New and Experienced Vapers
The Vapers Table
(10) Advancing Up the Vaping Ladder with Egos and Mods | E-Cigarette Forum
(4) Good Starter Setups for a Beginning Vapor | E-Cigarette Forum

 

[Robert Cromwell]

You may have put a temperatiure control coil in there and have it set to wattage mode?
If so you will get that message.

 

[Baditude]

I got a new k tech mini sub box and tank. It came with 3 atomizers. I put it all together and it says "atomizer low" I don't know what to do. I'm mad cause I waited 3 weeks for it to come in and it doesn't work

"Atomizer Low" means the coil's resistance is too low for the mod to fire it safely.

Your mod has a built-in ohm reader. What ohm does the coil measure out to?

The resistance (measured in Ohm's) of the coil should be inscribed on the coil somewhere, or listed in the product information paperwork. Try replacing the coil in your tank with a higher resistance coil. Be sure to "prime" the coil before you fill the tank.

 

[Gramdogg]

Yeah, even if it's a stock coil they are sometimes not connecting proper. Could be you didn't screw the coil in tight enough or at all if it's new and your using the one that was in it you should always clean new tanks and check the coil.

 

[Forkeh]

You may not have the device set to the proper wattage/temp (or you may be trying to vape wattage on a temp only coil, or vice versa). Or it could just be a bum coil. Sometimes you'll get a bad one. They don't always catch bad coils.

 

[MikeTay9779]

I have one and it could be that the pin is too far out....with it apart, gently push the pin on bottom of tank in and then screw in the coil snugly....put it all back together and see if it reads by pushing the fire button.