Need help. T2 short.

[rnln]

I just got a new kanger T2 from fastech and it short. I opened it up and found that the (+) pin tip at the coil part always touch the (-) outer perimeter on of the bottom part (inside the tank). On the pic below, the (+) on the right part always touch the (-) on the left part.

Anyone know if there should be a rubber seal there to keep them separate? Or how can it be separate?

The seal/o-ring between the (+) and (-) on the right part doesn't do this job. It's to separate the (+) and (-) on the right part only.

Thanks.

 

[lynch]

Mine do, is that the only one you ordered from them ? I ordered 5 from there but they are a week away.
The ones I looked at were from discountvapors.

 

[rnln]

Your does have the shorting problem or does have the seal there?

I order a T2 and a Cobra from them. Both have problem. The T2 is short and I can't fix it. The Cobra has a broken seal. They offered to refund and ship back, but I am asking to see if they can send me the seals.

 

[lynch]

Mine have the rubber and work great, but these are the discount vapor T2, I ordered 5 T2's from fasttech but they are not here for another week.

 

[rnln]

Good luck on the fasttech one. Please let me know when you see if they have it, if you have a chance. Thanks Lynch

 

[lynch]

Good luck on the fasttech one. Please let me know when you see if they have it, if you have a chance. Thanks Lynch

Tried loading a photo but keeps on saying it failed ? The pin from the base of Fasttechs T2 has a rubber grommet on the stem of it.
Looking at your photo and my fasttect T2 I see no difference mine work good.