Need help with broken Kamry K1000!

[Daniel_2017abc]

Hi everybody!

My K1000 stopped working (see pic), the yellow/beige rubber fell of and the tiny metal "head" at the end of the wire(s) is now loose. Ive tried to screw it it all togheter like i allways do, thinking that it should still work as long as the metal "head" establish contact with the coil. Its not working at all tough. Does anybody here know if this can be fixed?

 

[Daniel_2017abc]

Ok, do you think i could put it back there with a tiny bit of glue?

 

[Bonskibon]

Can't it be press fitted back together? Like this? I know it's not the same thing, but just to show the idea I'm thinking of.

 

[Daniel_2017abc]

The rubber ring is supposed to be behind/around the metal head, see pic.
http://www.imageit.com.au/dist/wp-content/uploads/2017/03/0pRsM8jf.jpg

Right now its only one red wire going to the metal head, is it possibly that it should be just one?

 

[zoiDman]

Hi everybody!

My K1000 stopped working (see pic), the yellow/beige rubber fell of and the tiny metal "head" at the end of the wire(s) is now loose. Ive tried to screw it it all togheter like i allways do, thinking that it should still work as long as the metal "head" establish contact with the coil. Its not working at all tough. Does anybody here know if this can be fixed?

You have to be Very Careful with this. Because your e-Pipe is a Mech mod.

And if there is a Short in a Mech mod, like that Center Pin making contact with the mod Body, you could cause the Battery to Fail. Perhaps Catastrophically.

Might be a Better idea to just Retire this Mod. And get something like this to replace it.

$33.55 Authentic Kamry K1000 Plus E-Pipe Starter Kit - 4ml / 0.2ohm / stainless steel + glass + aluminum + wood at FastTech - Worldwide Free Shipping

 

[Butch]

Don't waste you time or money on anymore Chinese made epipes there is not a good one out there. Any of the vendors listed here The ePipe Forum
Will stand behind thier products. Even so far as repairing it free of charge 5 years later for one. PipeSmith.

 

[Bunnykiller]

that is the insulator for the + pin on the "bowl" section... it seems as if it has torn apart and there may be the other part still inside the stem... if you plan to use some type of "adhesive", I would use a silicone ( 100% ) caulk of silicone gasket sealer ( blue).