Need help with eVic and AGA-T+

Status
Not open for further replies.

3angryinches

Full Member
Verified Member
Jan 30, 2013
26
1
california
I just got the AGA-T+ and added it to my eVic. It's running on 1.6 Ohms. What voltage should I vape it at? I currently run it at 3.5Ohms. I do get a temperature warning after hitting the eVic a few minutes. The warning temp is set to 35°C. Should I set it higher and if so, will this do any damage to my unit? Thanks for any help.
 

meli.

Ultra Member
ECF Veteran
Jul 10, 2012
1,030
938
Private Suite GroenDakkies
Hello 3angryinches and Welcome to forum,
Most Battery Mfrs state batteries should not exceed 60°C or 140°F in temperature.
Because you're running an LR coil you are drawing higher amps, this will make the battery get hot.
Increase your Alarm temp to the recommended cut-off and you should find things work a bit better.
;)
 

Trick

Ultra Member
ECF Veteran
Verified Member
Dec 14, 2012
1,655
2,846
Round Rock, Texas, United States
I just got the AGA-T+ and added it to my eVic. It's running on 1.6 Ohms. What voltage should I vape it at? I currently run it at 3.5Ohms.

I'm assuming you mean you run it at 3.5 volts, which should work relatively well with the 1.6 ohm resistance coil (though you can bump it up or down if it tastes better to you in either direction).
 
Status
Not open for further replies.

Users who are viewing this thread