Need more vapor!!!!

[dacookster]

Hi, I'm still too new to post in the real forums. I did a search, and it didn't really answer my question.

What's a great alternative to the eGo's? I am not getting enough vapor out of these. I am a heavy smoker, normally, and these units just aren't cutting it. Using, I think, a standard 2.8 ohm coil with std voltage batteries.

Help!!!

 

[happydave]

http://www.e-cigarette-forum.com/fo...cussion/498945-my-build-ego-octopus-mini.html

 

[dacookster]

That looks sweet, but I'd rather just purchase something similar? Not that I'm lazy, but I'm a Union carpenter as my day job, so when I'm off work, building something is the last thing I want to do!

 

[Steamix]

Try any of the dual coils like the iclear16 or iclear30. And 'not enough vapour' could translate to not enough nic flash. Waht's the nic strength you're vaping ATM ?

 

[happydave]

you will look long and hard to rival the performance for the price tag... rebuilding and RDA's specifically are going to give you the vapor production you are looking for.
you could try using juice with more VG than PG i run %90+ VG in my dripping attys
and check out the HH 357 dripping atomizer they are not cheap but everyone says they work extremely well

 

[Darkotic]

Hi, I'm still too new to post in the real forums. I did a search, and it didn't really answer my question.

What's a great alternative to the eGo's? I am not getting enough vapor out of these. I am a heavy smoker, normally, and these units just aren't cutting it. Using, I think, a standard 2.8 ohm coil with std voltage batteries.

Help!!!

Hey dacookster,

So you are using a regular ego battery correct? With something like an evod at 2.8 ohm?

If you don't want to get another battery, get a clearmomizer or replacement head with lower ohm like 2.0 ohm. This should increase your vapor production. 2.8 ohm is pretty high for a standard battery.

If you don't mind getting another battery get an "ego-c twist" or "vision spinner". These batteries are variable voltage so you can adjust the amount of vapor you want up or down with a dial. I'm thinking this exactly what you want, even if you don't know it yet.

Here's some links:

Vision Spinner VV eGo Battery 1300mAh
eGo-C Twist Battery - 650mAh 1000mAh - AltSmoke

 

[tomvonc]

I go with a vision spinner and a 1.8 ohm coil. Sweetspot for me is about 4v with my fave raspberry ice liquid. Best 20 quid I have spent so far after a couple of weeks wasting time on cheap fixed batteries ;-)

 

[dacookster]

Thanks everyone for the assistance. I'm using 12mg to 18mg Virgin Vapor, with I believe 2.4ohm coils. I'm going to upgrade to a VV battery and have some fresh coils on the way as well. I'm also going to get higher nicotine content vapor as well.

Thanks again everyone!

 

[dacookster]

Just ordered the vision spinner, some 1.5 ohm coils, and some juice from Wicked. Got the 30mg and 36mg stuff.

Will report back, and thanks for the help everyone!

 

[jac1766]

Careful with that insanely high nic juice!
Nic gives throat-hit but not Vapor.
VG content give bigger, thicker clouds.

Check out venerable vaping for Aspire BDC atomizers and heads. (ET-S model has Pyrex lining, holds close to 3ml and will hold up to tank cracking juices.)
They produce excellent flavor and Vapor production with little hassle.

The higher voltage/lower resistance is also correct. 2.8 ohms is best closer to 5 volts...

You should have stayed at or below 18mg nic... I started at 24mg and found that it was very sharp with a harsh throat hit...
36mg could turn you off of vaping!

 

[Bill's Magic Vapor]

More vapor?

Increase VG percentage.
Increase air flow.
Increase voltage/wattage (get variable vv/vw).
Make your own coils.
Increase number of coils.
Many others. Start there, learn, experiment and add as needed.

Good luck.

 

[Jazzi Mike]

I agree with the above posters. 1.8-2.0 ohms is around the best, even with VV. 30 and 36mg was too strong for me. However, good luck