Need some advice for mod

Status
Not open for further replies.

rbrtito

Senior Member
ECF Veteran
Verified Member
Mar 23, 2011
272
46
41
Southern CA
I'm currently looking into a mod but I started to get a little confused. Right now I'm using a ego 650mah battery with a LR306 atty. What is the difference if I went with a 3.7volt mod (ex. Puresmokers, provari, etc)? Won't it be the same as my ego battery, since the ego runs @ a 3.7volt too? I know with a variable volt mod i would be able to adjust the volts if I'm using a LR/HR attys to my liking. But I guess my question really is there a difference between my ego and a 3.7v mod? And if so what would be the benefits of going with the mod?:facepalm:
 

aziffel

Vaping Master
ECF Veteran
Verified Member
Nov 10, 2010
4,692
3,326
nc
The eGo is regulated to 3.2v until the battery gives up.A mod will give 4.2v at the connector(around 3.8 v with an atomiser on it) with a fresh battery,Quickly falling off to 3.7-3.8v for the majority of use,most protection boards shut down the battery around 3.5v
Mod batteries are less expensive than eGo batteries,that said,I still use eGo's once in a while for light flavors
 

cskent

Vaping Master
ECF Veteran
Jul 24, 2010
3,698
477
Ohio
Most mods, even cheap boxmods, run at a higher voltage. The batteries are also fairly large capacity, and less expensive. If you're wanting to try a mod of some sort just to see the difference, you can't beat the price of a boxmod. Most run at least a 14500 of around 900mah, start out at 4.2v, and can cost around $20. Add a set of batt's and a charger and you'll come in around $40. Check out this thread http://www.e-cigarette-forum.com/forum/e-cigarette-suppliers-forum/183648-quality-3-7v-box-mods-19-5v-box-mods-28-a.html. It's a cheap intro to the world of mods.
 

jazdale

Super Member
ECF Veteran
Verified Member
Feb 17, 2011
307
84
Jackson, MI
What would be an advantage of going to a 3.7v mod vs my ego?

The biggest advantage for me, was a box mod with a 3ml bottle (aka bottom feeder).
Very convenient and virtually zero maintenance.

No carts or tanks to spill and refill, very dependable, and inexpensive consumable parts (attys and battys)
 

Sewknitty

Ultra Member
ECF Veteran
Nov 12, 2010
1,425
98
NY
shesaquitter.wordpress.com
What would be an advantage of going to a 3.7v mod vs my ego?

I can't see one unless you went with, say, a high drain 3.7 big bat like a 18650 or 2650 for the battery life. If the eGo battery life isn't bugging you and you're not interested in varying your voltage I can't see a reason to give up a regulated, every hit pretty much the same (depending on your atty/carto) experience.
 

wv2win

ECF Guru
ECF Veteran
Feb 10, 2009
11,879
9,045
GA by way of WV
What would be an advantage of going to a 3.7v mod vs my ego?

The batteries should hold a higher charge longer (less drop off in power) and thus a better vape for longer and the batteries are not proprietary so you can buy them at many places and for much less. I can get a good 3.7v 1200 mAh battery for about $3.98.

But if you are really serious about moving up, there is a big difference in performance in a good 5 volt PV such as the GLV2 or the variable volt Darwin and any 3.7v device. I've used 15+ PV's at all power levels. There just is no comparison between the quality, throat hit, battery life, flexibility and consistency of a PV such as the Darwin and an eGo. I like the fact that I get 21+ hours of very heavy vaping on a charge and that the last inhale is just as good as the first after 21 hours. No drop off in power or performance due to the regulated power boost circuitry.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread