Need your advice ECF!

[JonAz]

Forgive my noobness as far as terms/abbreviations/knowledge goes.

I've been trying to get the right setup for over 3 years (check join date) on and off now without much luck as far as consistency goes. I'll find a setup that works well with my lifestyle and a week later it seems as if it doesn't taste the same.

I'm a very busy guy as far as work goes, I drive semi-trucks and I'm ALWAYS on the move.

My current setup in a simple 1000mah ego twist with a kanger protankII.

I would love to get some advice on a mec mod as well as a dripper and/or tank.

I love the look of the nemesis mod with the trident v2 DT. But where I'm failing at is a good, compatible tank, batteries, battery charger and any other accessories needed to get this mod working AND maintained.

If you guys could point me in the right direction, that would be outstanding.

-Jon

 

[itskohler]

List of supplies for Mech mod....
- Mod
- Atomizer (RBA/RTA, RDA)
- Resistence wire
- Choice of wicking material (I use organic cotton)
- High drain batteries (I use sone VTC4/VTC5 batteries, some of the best you can buy and owrth the peace of mind)
- Smart charger (I use NiteCore)
- OHM CHECKER! DO NOT SKIMP ON THIS!

And read, read, read. Battery safety, ohms law, coil building, and battery safety again.

 

[drummerskey]

Forgive my noobness as far as terms/abbreviations/knowledge goes.

I've been trying to get the right setup for over 3 years (check join date) on and off now without much luck as far as consistency goes. I'll find a setup that works well with my lifestyle and a week later it seems as if it doesn't taste the same.

I'm a very busy guy as far as work goes, I drive semi-trucks and I'm ALWAYS on the move.

My current setup in a simple 1000mah ego twist with a kanger protankII.

I would love to get some advice on a mec mod as well as a dripper and/or tank.

I love the look of the nemesis mod with the trident v2 DT. But where I'm failing at is a good, compatible tank, batteries, battery charger and any other accessories needed to get this mod working AND maintained.

If you guys could point me in the right direction, that would be outstanding.

-Jon

I would +1 and +1 again for the research and reading on battery safety and mech mods before a purchase. You could get a regulated mod and your experience may be better depending on what you get and then at least you have some protection. Personally, when I bought the Provari, the Protank II with an Aerotank base was worlds difference from the eGo Spinner and the iTaste 3.0.

If you are driving, drippers are probably out. When you get into more advanced tank systems like an RBA, if something goes down; you need to have an ohm meter, wick, wire, drill bits, scissors, tweezers and other stuff just to get right again. If you are really not digging your PT, I hear good things about the Nautilus. The coils are a bit more than the PT coils but the capacity is more and a lot of people really like them.