Needing a little help with Vamo V6

Status
Not open for further replies.

Piper86

Full Member
Aug 24, 2013
13
2
UK - Leeds
Hey Everyone!

I recently bought myself a Vamo V6 with an iClear 30S tank
Using the 2.1OHM filter coil thing it came with.

Got a question about what Wattage/Voltage I need to set it to.
I have it at 7W at the moment which I am getting smoke from but no taste from the oil at all.
I bought the oils from PimpMyVape which I am told are very good oils!

Would be great if someone can help me out with this.

Thank you :)
 

djsvapour

ECF Guru
ECF Veteran
Oct 2, 2012
11,822
7,901
England and Wales
I always enjoyed the iClear 30S

If I put it on a Vamo, I would run it at 12 watts minimum, maybe more.

I used my last one up 3 weeks ago, on an iStick. It was a tight draw but acceptable.

- -

Now and again, the replacement atomizers had a bad taste (metal taste) and I would take these out, rinse them in hot water and leave them to dry for a few days.

Probably needed to do that 2 or 3 times over the 15 coils I bought. :)
 

Frenchfry1942

Vaping Master
ECF Veteran
Verified Member
Jan 12, 2014
7,459
14,396
There is a fair amount of experimentation with vaping. I probably average 4.5 volts. Some juices seem better at a lower wattage (fruits) and some I enjoy a bit higher like coffee or pastries.

Taste is very subjective, so I just had to figure good ones out for myself. I like samplers, go to vape shops to share mine and try other's; friends, too. When I first started out, my taste buds were pretty ruined by smoking, so taste just wasn't to be had for a good while.

Keep reading ECF each day. It's a big world.

Have fun!
 
Status
Not open for further replies.

Users who are viewing this thread