I just got my hcigar Nemesis today and none of my tanks or rba's will screw down flush with the top cap. It seems like there's not enough threads for it to screw all the way down. I've taken the center post all the way out and they still don't go all the way down. Am I doing something wrong? Please Help!
Nemesis clone problem... Help Please
- Thread starter jpf880
- Start date
- th_trl_thread_readers 0
- Status
I would check the threads to see if maybe there isnt some kind of obstruction in the threads. Sometimes the makers leave a little scrap metal in there when carving out the threads.
They tighten and fire fine nothing loose or spinning like its stripped . There is just a gap between the bottom of the tank or atty and the top of the mod. I have a trident RBA , a Ibtanked carto tank, and Valley View Vapor carto tank, I also have a couple other RBA's that I'm not sure the makers.
I didn't see any kind of obstruction in or on the threads. It seems like its just short or not enough threads for them to screw all the way down.
I didn't see any kind of obstruction in or on the threads. It seems like its just short or not enough threads for them to screw all the way down.
Last edited:
Not sure what you mean, I have taken the screw-contact all the way out and its the same.
The nemesis and clones have a silver plated thumb screw in the top cap. The way I assemble it is I remove the atty base /top cap from the mod, back the thumb screw out, screw my atomizer in flush, tighten nemmy thumb screw, screw atty base + atty assembly back into the nemesis body, then tighten the bottom button snug to the battery.
Edit: just saw your last post. Yeah your threads on the atty or atty base may be boned
Edit: just saw your last post. Yeah your threads on the atty or atty base may be boned
Not to worry, some seem tight at first. My RSST was also stubborn.
There are only 2/3 threads on the Nemesis top.
With top off mod, grip nemesis top and tank. Twist in with pressure and back out. Do this a few times and the tank should seat. Maybe just use a carto so you don't have a spinning issue.(Carto tanks)
Once one fits, all should. Tightening may slightly press the Delron back from the threading. This is okay.
There are only 2/3 threads on the Nemesis top.
With top off mod, grip nemesis top and tank. Twist in with pressure and back out. Do this a few times and the tank should seat. Maybe just use a carto so you don't have a spinning issue.(Carto tanks)
Once one fits, all should. Tightening may slightly press the Delron back from the threading. This is okay.
- Status
Similar threads
- Locked
