Ok, so I love the silver screen mod, but it always seemed too tedious to try and cram the screens in the carts just to have to pull them out to refill again. Plus, I hate having nasty fillers that are made up of DOG knows what, so I was at work today, thinking of a way to better this mod. I tried a few folding methods a few days ago and found one that I think is pretty easy to lift out to refill. When I tried it with one screen, it all dumped into my atty, so then I tried two at a time. It held but after a while it still ended in the atty or my mouth. So here I am, thinking how to slow this down but not letting it dump.
Heres the Tut: pic of steps at bottom as an attachment
1)Use one screen and size up the PTB so its a square around the screen. Make your cuts.
2)Take the screen and form it to the edges of the cart so you get a general idea of where to bend screen.
3)Make sure that when you bend the sides of the screen, that the middle of the U is slightly bigger than the width of your cart.
4)Roll or fold the cut PTB so it fits in the middle of the U screen.
5)Fold the ends over like making a burrito.
6)Now make another U out of the burrito. Flip upside down. Fill cart up to or around ledges in cart with liquid.
7)Gently fit the upside down U into cart.
8)Press screen down about 1-2mm with something making sure that screen is touching all sides of cart. Then gently push cart on the atty. It shouldnt be too bad seeing as the prongs can fold in a bit if forced.
So far its been 3 hours, and only had a lil in the mouth. But I think I hit too hard and drew the liquid straight through.
Soooooo, Lemme know what ya think
Heres the Tut: pic of steps at bottom as an attachment
1)Use one screen and size up the PTB so its a square around the screen. Make your cuts.
2)Take the screen and form it to the edges of the cart so you get a general idea of where to bend screen.
3)Make sure that when you bend the sides of the screen, that the middle of the U is slightly bigger than the width of your cart.
4)Roll or fold the cut PTB so it fits in the middle of the U screen.
5)Fold the ends over like making a burrito.
6)Now make another U out of the burrito. Flip upside down. Fill cart up to or around ledges in cart with liquid.
7)Gently fit the upside down U into cart.
8)Press screen down about 1-2mm with something making sure that screen is touching all sides of cart. Then gently push cart on the atty. It shouldnt be too bad seeing as the prongs can fold in a bit if forced.
So far its been 3 hours, and only had a lil in the mouth. But I think I hit too hard and drew the liquid straight through.
Soooooo, Lemme know what ya think
