I was not too happy with the DNA30 screen cradles and board mounts available on shapeways and other sites. So I designed my own. My goal here was to keep the entire mount to no more than 3/4" wide x 1/2" thick. Length didn't matter for my particular setup as I had plenty of room in that dimension. I still tried to keep the length to a minimum though, so I ended up with 1 9/16" long. I haven't even yet had a chance to use these yet - my first order of them should be here Friday.
https://www.shapeways.com/model/227...board-mount.html?modelId=2270553&materialId=6
As this is my very first shapeways design, any thoughts from y'all would be much appreciated. This was designed for my specific use in a w-box style diy mod (pic of prototype below), but I imagine it may be useful for others.
I'll post once I have had a chance to use them.
~Moderators - if I'm not supposed to post these kinds of links, please remove.
https://www.shapeways.com/model/227...board-mount.html?modelId=2270553&materialId=6
As this is my very first shapeways design, any thoughts from y'all would be much appreciated. This was designed for my specific use in a w-box style diy mod (pic of prototype below), but I imagine it may be useful for others.
I'll post once I have had a chance to use them.
~Moderators - if I'm not supposed to post these kinds of links, please remove.
