New to this forum and i need help with the 4nine pls!

[VlohaHawaii]

So i purchased a 4nine clone from LaVapeco and since i got it every 3 or more hits i take the button gets hot. I messaged them about it and they said its perfectly normal. But i believe its not safe and i havent used it ever since. Does anyone know whats going on or how to fix it?

I use a Vulcan rda and Stallare v2 with sony vtc5 batteries with the 4nine.

 

[daleron]

Welcome to ECF Vloha ... I don't know but let's get you back on the first page so someone who does can answer you

 

[Harlen]

Hello and welcome
What do you call hot ?
If it gets realy hot then trash it and get a new one . I haven't had anything get overly hot .
If I hit it to long it will shut off but on the mec it will get a little hot .

 

[Warpigs]

Welcome to ECF!

 

[Sthur]

You can try and order the upgrade from fatdaddy.

SHOP - FatDaddyVapes.com - Home of the best vape tweaks and replacement hardware.

 

[amtseung]

First, clean off your mod. Take all the bits apart, and clean them with a degreaser. If you don't have a degreaser, a high percentage isopropyl alcohol will do. Next, make sure your artt isn't shorting. If your build is above 0.14 ohms and the button is still getting painfully hot in 3 hits, check your hybrid connector delrin spacer and your positive pin. Does it protrude enough? Does the actual positive pin protrude enough from the deck surrounding it?

If all this is good and you're still getting a hot button, maybe the 4nine isn't for you.

Good luck and vape safe!

 

[edyle]

So i purchased a 4nine clone from LaVapeco and since i got it every 3 or more hits i take the button gets hot. I messaged them about it and they said its perfectly normal. But i believe its not safe and i havent used it ever since. Does anyone know whats going on or how to fix it?

I use a Vulcan Rda and Stallare v2 with sony vtc5 batteries with the 4nine.

Maybe you're using a very low ohm coil compared to the 4nine clone button ohms.