Hi i have a aspire adjustable air flow just out of the box and its starting to gurgle :/ and i can taste the liquid also what v/w should i use for this tank 
New user
- Thread starter Kaan709
- Start date
- th_trl_thread_readers 0
- Status
Did juice get into the chimney? Is coil secure into its seat? Is the base securely attached?
Also, what ohm coil are you using? You're asking a lot and giving so little. I suggest placing a paper towel at the end of the aspire and blowing into the drip tip, forcefully, to clear the chimney of excess juice. Restrict your airflow and take a few puffs, than slowly increase it to your liking.
Sent from my XT1028
Also, what ohm coil are you using? You're asking a lot and giving so little. I suggest placing a paper towel at the end of the aspire and blowing into the drip tip, forcefully, to clear the chimney of excess juice. Restrict your airflow and take a few puffs, than slowly increase it to your liking.
Sent from my XT1028
If it's the nautilus did you underfill it?
These tanks rely a lot on a vacuum to hold the fluid in the tank. If you underfill it takes a while to build up that vacuum, and while this is happening the juice will run quite freely into the atomizer.
A point of interest:
It's a 5 ml tank. I've found the measurement scale printed on the tank is way off. By measuring 5ml with a syringe into the tank I found there was just enough room to get the base back on without squirting fluid everywhere. Left only a small bubble at the top of the tank.
These tanks rely a lot on a vacuum to hold the fluid in the tank. If you underfill it takes a while to build up that vacuum, and while this is happening the juice will run quite freely into the atomizer.
A point of interest:
It's a 5 ml tank. I've found the measurement scale printed on the tank is way off. By measuring 5ml with a syringe into the tank I found there was just enough room to get the base back on without squirting fluid everywhere. Left only a small bubble at the top of the tank.
- Status
Similar threads
