New Vamo v5 and KangerTech ProTank 3. Where to start?

[LunchNmunch]

Just got in a new Vamo v5, batteries are now charged, and the KangerTech ProTank 3 has had juice in it for a couple of hours now.

What settings should I start at? It is showing 2 ohms. Should I set the voltage or the wattage and at what setting?

I gave it a go at 4.3v with a vanilla flavour and it's really bad. It's been 2 weeks since my last cigarette. Could this be a sign of vapour's tongue?

 

[MrPlink]

Rule of thumb is start at the lowest setting possible and work your way up.
Volts or watts, it's up to you. Just different ends of the same equation.

Protanks don't wick liquid horribly fast, so at 4.3 you may just be burning your juice

 

[LunchNmunch]

So, I should be adjusting just the volts or just the watts?

I took this approach with my original CE4 tank and started on the lowest voltage 3.0 then went to up by 0.1 until it got small amount of the burnt taste. Then just put it back down by 0.1 and I was fine.

 

[classwife]

Moved to Variable Voltage APV Discussion from APV Discussion

 

[GeorgeF]

So, I should be adjusting just the volts or just the watts?

I took this approach with my original CE4 tank and started on the lowest voltage 3.0 then went to up by 0.1 until it got small amount of the burnt taste. Then just put it back down by 0.1 and I was fine.

you just answered your own question. But, to help you out start at 3.7 volts and work your way up to the burnt wick taste then back it down to where you get the most flavor and vapor you can get.
you probably wont get much over 4 volts before getting a bad taste.

 

[SunshinePete]

Just got in a new Vamo v5, batteries are now charged, and the KangerTech ProTank 3 has had juice in it for a couple of hours now.

What settings should I start at? It is showing 2 ohms. Should I set the voltage or the wattage and at what setting?

I gave it a go at 4.3v with a vanilla flavour and it's really bad. It's been 2 weeks since my last cigarette. Could this be a sign of vapour's tongue?

Using exactly that setup, except my coils are 1.5 ohm, I have the Vamo set between 10W - 12W.