newbie cotton wicking "trick"

Status
Not open for further replies.
I am sure that all the experienced vapers knows this or a better way of doing it. but here is my way.
After I got my first rda I was using 32 gauge for coils, I found that replacing the cotton wicks was bothersome and often screwed up the coils. After some tinkering I discovered that pulling in both ends of the wick will make the wick separate in the middle and keep the coil intact.

just a little advice for the people new to this and perhaps experiencing the same problem.
 

wi11n

Full Member
Oct 14, 2013
42
20
Usa
image (1).jpg:2c:
 
May 8, 2014
0
2
San Diego
  • Deleted by The Ministry
  • Reason: Unregistered Supplier
May 8, 2014
0
2
San Diego
  • Deleted by The Ministry
  • Reason: Unregistered Supplier

Kr3wsk8er

Unregistered Supplier
ECF Veteran
Feb 1, 2014
241
227
SB/LA 808-213
Different kanthal gauges, coil builds, pulling cotton through, as well as cotton beds, are all dependent on your skill set, and preference. Do whatever floats your boat, and gives YOU the vape YOU want. I always lulz when I see someone trying to say that one way is the best over another. Everything has its pros/cons.
 
Status
Not open for further replies.

Users who are viewing this thread