Newbie here help

[sonic1971]

im using my new vamo v6 i have notices a couple of my vivi nova are different heights the (in the middle) which also gives me a problem when getting new atomizers some fit some dont... but i have just bought 2 new vivi novas and my have been coming up with "without atomizers"so i changed atomizers on both off them still telling me without atomizers any ideas how i can fix this problem???? thanks in advance for any help give

 

[FineStore]

To be honest, Viva Novas aren't terrible consistent or very good. Without a pic its difficult to fully analyze your problem, but you want to make sure the contacts can touch each other. If they can't touch it will read as no coil

 

[djsvapour]

Stop buying Vivi Novas?

I wish I could help, but I'm not sure I understand. I bought some Vivi Novas that were so bad, they shorted and killed my eGo batteries.

Are they Vision brand ones or just no brand? Aspire make some with the name Vivi Nova, they would be reliable normally.

Old tech, not good, potential battery killers, unmatching/incompatible threads and sizes. Lots of reasons to not use them in all honesty.

(Sorry....)

 

[EBates]

Welcome aboard
I never used them, so I'm no help.

 

[nggenah]

Welcome aboard
I never used them, so I'm no help.

me too sir,sorry

 

[Bassnorma]

I don't have experience with those models.

However, I can tell you this, "No Atomizer". "Check Atomizer" type messages can indicate that the firing pin (the part of the Clearo or atomizer which touches the battery's 510 connection) is not making good enough contact with the battery. I looked up the version 6 VAMO and it looks like it may have an adjustable 510 connection. This means it would spring slightly up and down to accommodate differences in atty firing pin length. If you take a pencil and poke the 510 connection, does it move up and down or is it fixed?

If it moves you could try to pull it up very gently with some needle nosed pliers. I would do this as a last resort after trying the next bit below....

The other possibility is that the coil is not screwed into your clearo tightly enough. I have had that happen on Kangar tanks. I thought I screwed it all the way in but it needed that final twist.

So, first check if the coil is screwed all of the way in and then check the 510 pin on your VAMO.

Hope that helps!

 

[sparkky1]

I would try moving the pin up with a toothpick.....

 

[sonic1971]

vision brand lol my local shop says they are stop using them but that just makes me have to learn more about rebuilding them lol thanks

 

[sonic1971]

pushed the fireing pin at the bottom as well both moves freely found some older ones that seem to work so am back on the vape train yeeha

 

[sonic1971]

thanks very much got it working again so happy

 

[sonic1971]

np guys thanks for ur help )

 

[Frenchfry1942]

Yes, I wonder if the pin is not connecting to the bottom of the tank. As was said, try a toothpick, delicately.

 

[sonic1971]

duh!! thanks guys tryed most off u ideas got it working again im back on the vape train

 

[twgbonehead]

Hi, sonic, Welcome to ECF! Glad you got the problem fixed!

A handy thing to have in your toolbox are something like this:

https://www.fasttech.com/products/0/10003955/1473305-510-to-ego-adapters-for-e-cigarette-5-pack

These can get you past a bunch of different problems with heads that don't connect properly!

 

[OldLadyO]

Hi Sonic, I use a couple of vivi novas. They're a good tank, I've never had a problem with them.