Newbie here with eVic question

[wallacecarey]

My eVic has a vapor setting with options vv, vw, rvw1, rvw2 and rvw3. What are these and the differences between them.



regards,
Wallace

 

[Whiplash205]

VV = variable voltage mode
VW = Variable wattage mod
The others are an evic only thing. You can use the PC software to tailor your vape. Ie: star off at 4 volts for 2 seconds then down to 3.7 for 4. I don't really see any benift to using those. I just run mine in wattage mode.

Sent from my EVO using Tapatalk 2

 

[crxess]

Correct, all or your (R) settings are for custom tailoring your power output.
While I have not used them(I'm lazy that way) other that have seem to like the results.

Say you like short draws, or have lung issues that do not allow you to take long draws(shortness of breath)
The coil may not heat up properly to Vaporize e-liquid
Poor solution Crank up the Volts
Better solution - Raise output to (x) for .5 seconds, reduce to (Y) for 1.5 seconds, continue at (Z) for 6 seconds.
Now you can come on strong and level off lower to keep juice from burning.

 

[Sthur]

Varrible wattage is great. It will adjust the voltage in smaller increments. Plus easier to set to recommended setting and adjust to your taste.

 

[Arnie H]

Welcome aboard.

 

[NiNi]

If you go to the eVic thread, there's a link for the 1.4 upgrade: http://www.e-cigarette-forum.com/forum/evic/457115-firmware-1-4-out.html and here's the link to eVic in general:eVic

 

[xecks]

Nice I wanted to know what those other modes were. Thanks!

 

[mik385]

Try install the software included.. There are nice function...

 

[Attila79]

Hello...i use Evic..and its great..only one think i need 2 ask..in settings i have from 3.0V to 5.0 V and 3.4W to 9.6 W ...I use 2.4 ohm..i think it go to 12 W ...NO ?! My only 9.6 W