No coil screen

[Jack Smart]

I need help!!!! So I upgraded from a smok rpm80 and now I have a aegis legend x Zeus edition it has a side screen and it keeps saying I have no could but i do what do I do to fix this?!?!?!?

 

[Beamslider]

Do you mean "no coil"? Not making contact with mod or coil is loose in atomizer.

 

[Jack Smart]

The screen keeps saying that I have no coil even tho the coil is in the tank and connected to the mod

 

[Beamslider]

Either the pin on the tank is not making contact with the mod or the coil is not installed in tank right would be most likely cause. Take tank off of mod and make sure it is clean and check coil. then put back. The pin on the tank may be too short to make needed contact.

 

[Jack Smart]

I have cleaned it and checked the coil they are good! I have the tank it came with it was the Zeus tank, what should I do then if it’s too short?

 

[UncLeJunkLe]

There are a lot of ideas and suggestions here

 

[Hawise]

Have you tried it with another coil? The occasional coil is a dud, so sometimes a new coil will do the trick.

 

[DallasLiza]

I've had a Zlide in rotation for about a week. Last night, I got 'no coil detected' on Solo mod. I cleaned the 510 connector with alcohol and reseated the coil. No fixy. I put the Zlide on two clean Picos, Asmodus Colossal & Vaporesso Gen S - no coil detected on any of those. I assumed the coil must be spent so before pitching it I attached the Zlide to an old Clover Overlord pen style battery and it fires.

I looked at Innokin Zlide trouble shooting vid
Innokin/Platform ZLIDE Atomizer - Troubleshooting - Video | INNOKIN®
and read
How to Fix 'No Atomizer' or 'Check Atomizer' for vapers

After doing all this I remembered I put that Zlide tank aside a couple months ago for the same reason - I started getting 'no coil detected'. No warning, just bam - it quits working.

Am I overlooking something obvious? Here's a pic of all mods I tested with & Zlide is connected to the Overlord which does fire but, of course, it's not a great hit.