Just received my aeroflow base for my PT II today. Installed on one of my PT II"s and I get a "non" ohm reading on my VTR and it is not firing at all. If I put the original base on, it reads 2.1-2.2 ohms and fires just fine. It is useless though on my VTR because there is no draw at all. Have three PT II's and the same thing happens when I install the aero base on any of them. Any thoughts?
"non" ohm reading after installing aeroflow base on PT II
- Thread starter Elendil
- Start date
- th_trl_thread_readers 0
- Status
it would appear the air controller forgot to pass the positive current to the protank head. you failed to mention weather it works at all on other devices.
Check the bottom center contact on the coil assembly. I had this problem with my pt mini and my vv. Pull the contact slightly, the insulator grommet may have gotten compressed and not making good contact with the vtr.
Sent from my SPH-L720 using Tapatalk
Sent from my SPH-L720 using Tapatalk
- Status
Similar threads
