O-Ring and Washer sizes

[DevilFishPhil]

I searched high and low, but I can't find the exact dimensions of the O-Rings and washers used in the Precise P18 (I just found a thread about the o-rings in the DTs. Would it be possible to list the exact dimensions (and perhaps part #)? I'd love to have a few extras lying around just in case...

 

[forcedfuel50]

I searched high and low, but I can't find the exact dimensions of the O-Rings and washers used in the Precise P18 (I just found a thread about the o-rings in the DTs. Would it be possible to list the exact dimensions (and perhaps part #)? I'd love to have a few extras lying around just in case...

Sure, i'll get the specs up for you in the morning.

 

[DevilFishPhil]

Any update on this? Thanks!

 

[forcedfuel50]

Washers are a #8.

Orings are:

Thick .100: #113
Thin .070: #16

I've been meaning to put some parts kits up on the site, i'll try to get them up in the next few days.

 

[DevilFishPhil]

Thank you so much for that, and yes parts kits would be a great idea. Even though I know my P18 is near indestructible it's always comforting to know that I have extra parts in case something happens.

 

[cy1970]

I mis-placed the o-rings (thicker in size) when cleaning my P16. What is the size of the O-ring (dimension in mm) or can I get them from you, Dave?

 

[forcedfuel50]

The P16 utilizes a -112 oring, you can find them most anywhere but heres an example:

Amazon.com: -112 Viton O-Ring, 75A Durometer, Black, 1/2" ID, 11/16" OD, 3/32" Width (Pack of 25): Industrial & Scientific

 

[cy1970]

The P16 utilizes a -112 oring, you can find them most anywhere but heres an example:

Amazon.com: -112 Viton O-Ring, 75A Durometer, Black, 1/2" ID, 11/16" OD, 3/32" Width (Pack of 25): Industrial & Scientific

Thanks Dave for the size. I managed to get them from local supplier.