OBS ENGINE NANO HELP

[Nckllclr]

Hi there fellow vapors! I am new to vaping and purchased an OBS Egine Nano. After priming the pre built included coil, I began experiencing extreme dry hits immediately following the first 4-5 hits, which were fine. It seems like the juice isn't reaching the coil. What am I doing wrong? Please help. Here is my setup:
Trinity V2 40w mod box
510 connection
Operating voltage 3.2 - 4.2V
Max output current 20A
Built-in 1200 mAh battery
Power and temp control atomizer working resistance range 0.1 ohm - 3.0 ohm

I put a magma paradigm rda on the same mod and it hits good, but I really want to use the OBS rta. If you have any experience with the OBS Engine Nano, please share. Thanks!!!

 

[Letitia]

Welcome to ECF.
When you wick Nano leave a shoulder at the top of the wick and comb the tails with your tweezers to thin them. Cut tails so they just tuck into the wick channels. Might take a few times before you find what works best for your juice and how you vape. I'd keep my af wide open until you hit on the right wicking, then play with af.

 

[Nckllclr]

Ok, I'll wick it again and hope that it works. Thanks for sharing!!!

 

[Nckllclr]

Tried it, now loving it. What a life saver you are. Thank you thank you!

 

[Letitia]

Love my Nanos! Once you get it dialed in it's hard to beat.

 

[BrotherBob]

Tried it, now loving it. What a life saver you are. Thank you thank you!

Welcome and glad you joined.
Magma, great choice.
The information below may help you with tank future problems.
Might like to read:
Tank Flooding Explained | Learning Center | VaVaVape
Most Frequently Asked Vaping Questions Part 2
https://www.e-cigarette-forum.com/f...atomizers-for-new-vapists-how-they-work.5250/

 

[the wind]

you make a super chose on the tank,its my favorite rta.hope you stick around.