oddy terminator c VS oddy transformer c VS fogger.........

[rogergendron1]

alright guys i own a fogger and for the life of me i cant get it working right lol

i cant fill it all the way without a massive flood !
it ether overflows or dry hits
and i keep getting minor shorts at the positive post !

i know a lot of people rave about this but i have been at it for 3 days and i just dont like it so far i feel like i wasted 35$

i built it with ss mesh
with silica 3mm
with cotton and standard coil
with cotton micro coil
with cotton vertical micro coil
and a bunch of the above combos with stuffed chambers full of differant cotton style beds

i am about to give up and get a terminator lol is the termanator any better than the fogger ?

 

[WattWick]

Very much a personal opinion: I wouldn't get a Terminator now. Why mock about with joining res/no-res wires when you can get a probably better vape out of a kayfun or the like. To me, the Terminator was a fad a while back, but you rarely hear anyone using them anymore. I'm sure someone will come along and prove that at least 1 person still think they're the bees knees

I'm sure someone will come along and help you out with your Fogger, tho. Always worth having a few second opinions on what might be causing your problems before spending more money

 

[Gimpy1261]

IMHO no a terminator is not better basically they are the same thing. Both were hard for me to get working right but when you get them right they work great and stayed that way until I tried building differently. I hope you get your fogger going, because if you do it's like having an orgasm!

 

[rogergendron1]

lol i have read many people who run the teminator/transformer oddy clone without the no res wire as one side is real short and doesnt need it and the other side is run under the wick in the channel so it stays wet and will not heat up unless you short the coil somehow. i have read a lot of people who run the oddy and ithica clones with just strait wire using 28 or 26 guage and have never had a problem. even so i dont mind the binding of a lil no res wire here and there if the quality of vape and ease of use makes it worth it plus i am more of a silica guy than a cotton guy but cotton comes in second and i dont mind using it if thats how the fogger works best.

now can any one tell me if the oddy clones are any better than the fogger ? or is the fogger just as good ?

i seeem to like the idea of juice flow control over air flow control.... the oddy you can easily adjust the juice flow with the drip tip but the fogger is not realy meant to be adjustable, ... even though it can be.... but its difficult to do and throughs off your setup by seperating the glass tube and loosening it as you open the juice flow via the center tube. the fogger is meant to be set juice flow and only used as adjustable air flow where the oddy has set air flow and adjustable juice flow....

does any one have and use bolth and if you do witch do you prefer ?

also if you have pics of and or a description of how to make a great fogger coil (preferably with silica, but cotton is ok) i would be greatfull !!!



also the russian 91% .... how about that ? is it worth the cost ? and is it easyer to set up than a fogger ? does it have juice flow control or just air flow ?

any way here i sit using a rebuilt kanger unitank cause i cant get my fogger .... umm well .... fogging lol
i have found that its easyer for me to build a protank coil in that tiny lil cup than it is to rewick a fogger cause of how the base and the posts are set up ! right now i am running a 28g 1 ohm micro coil with a piece of 3mm silica in my kanger unitank and its flawless ! i wish i could get my fogger working like this !