Official ProVari 3 Thread - P3 *PART 2*

Status
Not open for further replies.

DPLongo22

"Vert De Ferk"
ECF Veteran
Verified Member
Dec 17, 2011
32,962
182,726
Midworld

DPLongo22

"Vert De Ferk"
ECF Veteran
Verified Member
Dec 17, 2011
32,962
182,726
Midworld
Well, here's to NEVER growing up! The closer we get to growing up, the closer we are to the er, uh........the end. So stay young, at least in heart and mind. That's what I say. Yes I do!

RIGHT??? "I wanna be a Toys-R'Us kid!"

DP is really Archie Bunker ?

:blink:

Well.... not quite as good looking (if I must admit). :D
 

DPLongo22

"Vert De Ferk"
ECF Veteran
Verified Member
Dec 17, 2011
32,962
182,726
Midworld
Number 41799. That's me. ;)

Number 41800. That's him. ;) ;)



Any questions? :D

Look, it's all about the fashion, and DPL and I are nothing if not fashionisti.

So TWO more Katbukis are now en route. :D

Getting those GMZs ready for their new hats!

Just caught this. You are TOO MUCH! :lol:

And since we know Zen is watching this thread, is there ANY CHANCE you might come out with a larger size? 2ml is just SO tough.

And yet, we've still ordered two each. ;)
 

Freedom2Vape

Ultra Member
Supporting Member
ECF Veteran
Verified Member
May 8, 2015
1,579
7,547
Texas
Ah. See on the P3 version, it's mucho differento.
Once the coil is installed, if you turn the base upside down, you see the bottom of the coil in the center of the P3 connector...like putting your finger through a donut...
Mmmmm...donut...[emoji507][emoji507][emoji507][emoji507][emoji507][emoji507]
Anywho...the coil is screwed in, just like on a nautilus, and that's it. No grub screw to hold it in, no spring loaded pin to bridge the link to the pin of the mod...the coil's own pin makes direct contact with that of the Provari...
I haven't played with it, but I can reasonably assume that if I screwed the airflow grub screw all the way in, it might hit the coil...which would keep the coil from seating all the way. It's a good reminder to keep that airflow grub screw backed out, at least far enough so that it doesn't hit the coil. I keep mine flush with the outside of the base.
For those of you familiar with the airflow setup on a kayfun 3.1, the Kabuki P3 is fairly similar...with a grub screw that goes directly in toward the pin, and a sideways airflow hole, whose path crosses that of the grub screw, allowing said screw to close off the airflow as needed.
Sorry if this has already been asked - I started at the beginning of this thread and still have about 60 pages to go...any comments about the flavor on the Kabuki P3?

Best Regards,
F2V
 
Status
Not open for further replies.

Users who are viewing this thread