I'm still looking at the steam crave but for now I'm waiting for the fatality, not hoping any time soon as slowtech keeps advancing the delivery date, not their fault as the virus as caused delays
- Status
Fatality? Could you please tell me more about that please @Marper, as haven't got a clue what you're on about there.
But I'm waiting for a price drop on the Hadron, as well as the Squonk addon. As it's always good to have a Squonk mod or 2 in the stash, but it's hard trying not to spend money of things that you want and not need.
Much prefer spending a small large fee on some decent atomisers, clone or genuine.
But I'm waiting for a price drop on the Hadron, as well as the Squonk addon. As it's always good to have a Squonk mod or 2 in the stash, but it's hard trying not to spend money of things that you want and not need.
Much prefer spending a small large fee on some decent atomisers, clone or genuine.
QP has always produced in smaller batches in comparison to China companies. The Fatality can still be found in Canada (QP is a Canadian company) but suspect shipping to the UK would be a small fortune.
Own the Fatality – great RTA, the dual airflow works well.
Ah, thanks for clearing that up for me @Marper. I've been mulling over the Ulton clone, as it's pretty much a 1:1 version.
Just a little skeptical over the plastic airflow insert that close under the coils, could be interesting and not necessarily in a good way. But I've heard good things about QP Designs.
Just a little skeptical over the plastic airflow insert that close under the coils, could be interesting and not necessarily in a good way. But I've heard good things about QP Designs.
So wicking seems to be my issue, I changed out coils and tried wicking with the cotton looser and all is well! ohms are showing a steady .165 which is reassuringly closer to what it should be for my dual build. I was quite surprised that I found coiling very straightforward but wicking is quite the art!
Well done, yes wicking is an art form but I can't see why the wicking caused problems with your ohms, i build then check the ohms first after a little dry pulse and then fit the wicking when I'm satisfied, i think your issue might have been a bad connection somewhere that caused the problem, but fantastic you sorted it 
The only way wicking can cause a problem is if it's too tight and causes the coils to close up when you pull the wick through,causing a hotspot but that would result in a short or very low reading
True @a1m330910, a coil takes a few minutes to sort. Whereas wicking can takes eons, or what seems like it.
Hi everyone, it's been a while but just wanted to say a big thank you to everyone who helped me at the start of me dabbling with rebuildables. I found everyting quite frustrating to start off with but after reading comments I decided to upgrade my mod and did a lot of research. I've now been exclusively vaping for 2 months so thank you all
Practice does indeed make perfect. I have a dead rabbit too. Nice rda, not absolutely killer for flavor but good enough. Does your ohm meter give correct resistance when you check it? Not stable but correct as in .16 to .19 for your dual build? If so, then the mod isnt reading right.
I know it sounds pedantic, but what changes is resistance. Which is measured in ohms.
You don't press the gas pedal on a car to go more mph.
You don't press the gas pedal on a car to go more mph.
- Status
Similar threads
- Locked
