Pictures of your setup

Status
Not open for further replies.

Ulmer

Super Member
ECF Veteran
Verified Member
Jul 29, 2012
689
766
Ulm, Germany
The mod is an ADAM, the atty is a COBRA rba.

Adam%26Cobra_.jpg
 
Last edited:

Kable

Ultra Member
ECF Veteran
Verified Member
Nov 29, 2012
1,134
1,538
Davis, CA
Kable I have tried that as well lol still end up sideways. Going to have to spend less time designing this mod around a chip I dont have yet and figure out how to post a straight pic hahahahahaha :laugh:

I was just giving you a hard time, but if you want a real idea, and you're using an iPhone, I just downloaded and tested photo editor by aviary (lots of other choices, just the first one I tried, I'm on an iPad), and you can rotate your photos using the orientation button.
 

badinfluence357

Ultra Member
ECF Veteran
Verified Member
Jun 17, 2012
2,596
6,243
NYC
kwalka: That setup looks like it has not been used!!! Show me those coils when used a couple of days :laugh: and then say it again.

Kwalka who made the extra wick hole for you??? I did it on my cheep attys but don't dare go ahead and do it on my did...I'm affraid to F-up the hole and make it to close to the positive pole

Sent from my SCH-R910 using Tapatalk 2
 

MrJonesJr

Senior Member
ECF Veteran
Verified Member
Jun 27, 2009
103
90
Philadelphia, PA
WOW Mr. Jones. Those look very nice. Did you polish your Provari yourself?? I am getting tired of my silver satin finish and would like to strip it. Could you PM me how you got it that way??

Thanks Edson!! I used 800 and then 1000 grit sandpaper lightly by hand (the satin comes off almost instantly). Then Mother's Mag and Aluminum polish with a cloth to polish it. Although i am sure there are more professional ways to do it, it only took me about 10 minutes :)
 
Status
Not open for further replies.

Users who are viewing this thread