Pictures of your setup

Status
Not open for further replies.

panomano

Senior Member
ECF Veteran
Aug 1, 2013
104
179
41
Callisto
Thanks buddy, i think i will try and redo the wires inside once i am finished with the liquid. Its hard to maintain the resistance that is measured on the multi meter when attaching the normal wires to the resistor wire, when i tighten the knots the length of the resistor wire increases a bit and always reads more after i am done attaching the normal wire legs.

Anyway, thanks for the tip. attached another pic of the collection that is growing at the office :)

 

MoDmAnDaN

Ultra Member
ECF Veteran
Verified Member
May 31, 2013
1,157
1,103
61
Spanaway, Wa.
Thanks buddy, i think i will try and redo the wires inside once i am finished with the liquid. Its hard to maintain the resistance that is measured on the multi meter when attaching the normal wires to the resistor wire, when i tighten the knots the length of the resistor wire increases a bit and always reads more after i am done attaching the normal wire legs.

Anyway, thanks for the tip. attached another pic of the collection that is growing at the office :)

Hope it helps you, I was fighting mine for a week. Trying to figure out why I was getting a massive throat hit, but not much vapor. Then I watched a YT video by Bishopheals and he explained the best ways to build it!! I'm planning on watching more of his stuff and trying quad coils on mine.
 

Pstarsr

Senior Member
ECF Veteran
Aug 4, 2013
166
100
Santa Barbara, California
ge4evyje.jpg


Got more gear

Kanger mini protank, ego-c twist battery with standard ego cone and boge 510 xl cartomizer, smok dual coil mega ego cartomizer, then my standard ego-c setup.


Sent from my iPad using Tapatalk Which doesn't work 50% of the time
 

MoDmAnDaN

Ultra Member
ECF Veteran
Verified Member
May 31, 2013
1,157
1,103
61
Spanaway, Wa.
quad? as in stack them on top of each other? bananas!
found the guy bishop heals and watching the movies

I know huh? But he's also talking running 6 coils. I just don't see why unless it's just bragging rights and you have a ton of batteries and carry 50ml of juice with you.
 
Last edited:

chadsmo

Vaping Master
ECF Veteran
Verified Member
Feb 16, 2013
5,267
11,281
BC Canada
had to rebuild the atomizer to single coil because i couldn't get it to fire hard enough with two coils. No idea why it wasn't firing good. Had the same taste as you get when the battery is dying.

Seems to work well with single coil though, wrapped at 2.2 ohms. Perhaps battery will last longer this way

edit::..
the dual coils were build from the factory. tasted bad too, almost like how the machine lube smell


I'm going to assume that means you didn't take it all apart and boil it then? If not strip it all apart to every little bit, remove all the o rings if you want to be safe, and boil it for at least a few minutes.
 
That is just a thing of beauty! Custom made of can it be purchased??

Sent from my SPH-L900 using Tapatalk 4
The tube is made by Senio, only one, for me :blush:
You can get the wood atty, but the list is HUGE! (and temporary closed) :evil:

There's similar setup - with the dripper by Senio:
 
Status
Not open for further replies.

Users who are viewing this thread