how about a short review of the tank and diver? been thinking of getting the same setup but wanted to hear about it some more...
Absolutely:
I run resistance wire only, pretty easy to set up. Like recoiling a vivi or pro tank coil. I've not had any issues with the hot tails burning my juice. I use .05 flat wire for a 1.3 ohm coil. Have to note where the juice feed hole is when u screw down the sleeve so the wick is perpendicular to it. Also make sure the ceramic cup and brass pin r fitted in snug and the pin is all the way in. After that it's like any carto tank system.
For me set up is a bit more steps compared to my Kayfun. It's good if u have tanks u used for cartos and can now use this. The draw is a tad tighter than I prefer, I've played with the pin and got it a bit better. Flavor is very good, I saw a review that said it was better than a Kayfun.......not imo but a good atty nevertheless. I will keep it in my rotation for now, and it looks dang good on my Lux 2.5.
Ken
edit: I have cut the wick at the edges of the ceramic cup. I have also left one end of the wick longer so I can lay it around the ceramic cup while mounted. Each worked, I have experienced dry hits if I chain vape both ways. I think the 1 feed hole isn't enough at times. I usually dry hit it regularly to avoid that nastyness. Not sure if another hole or bigger will work as it will likely flood. So just need to remember to take dry pulls often.
Sent from my iPhone using
Tapatalk