- Status
poldiac and DCT titanide with titanide driptip titanium
Is it the light, or is your Poldiac brass? Very, very nice setup!
Wish the Poldiac and Nemesis weren't so hard to get! Either would be a nice addition to my collection.
Sent from my phone with an identity crisis.
That sorta looks like an Evic head on that! Mind sharing how you got that done!
Sent from my phone with an identity crisis.
Sent from my phone with an identity crisis.
Last edited by a moderator:
Now that is nice! I would very interested in when your next batch is available! A telescoping mod for the Evic, never would have thunk it! Like your beauty ring much better as well!
Sent from my phone with an identity crisis.
Sent from my phone with an identity crisis.
Last edited by a moderator:
NICE!! Two days turns into three
In my first few days, I think I chain vaped every chance I could and went through I don't know how many cartos. Keep at it. And, if you haven't already, pick up a few sample packs of other flavors. I nearly went back to analog after 2 weeks due to suddenly losing the "taste" of my preferred juice. It just didn't taste like anything but air, and really didn't hold my attention. Once I got my first few orders and sample packs from people like mount baker Vapors, I started to figure out what I liked and was able to keep off the smokes.
Good luck!
Thanks Matt. I appreciate the advice big time!
Mine is basic compaired to what everyone else has.. mine is a VAMO V2 in 18350 mode with a 3.5mL DCT vaping cinnamon red hot @ 18mg
Something a little different today. A Original Copper Hex at 6v with an Octopus at 2.8 ohms.
Provari. Spheroid. Green. Perfect. (I'll post pictures of it with the Kayfun once my prorings come in).
What I have bought in the last month or so...and a solo shot of my fave atm.
New toy came in today:
Nemesis #1717 in 18350 / 20mm ring / Nimbus
Group shot:
Nemesis 18650 / nimbus - Poldiac CW 18350 / ZAU - Paps 2.1 18500 / ran out of atties, I left them at work
by any chance do you have a steam turbine to test that cap on? since that's the atty mostly use on my nemmy it would be nice to know before I order one
I made it myself. It took about 2 1/2 hours. Total cost of materials was less than $2.00. That's an actual oak barrel. I found a solid wood model of an oak barrel. I used a spade bit to drill out the core. I cleaned it up with a dremmel. Then I cut & drilled corks for the caps; popped in The Diver RBC and some spiced peach from Timeless Vapors... didn't have any whiskey!!! But still... a tiny hint of oak comes through. I decorated it with two tones of shoe polish and linseed oil, and a sharpie. I don't know why I thought of this. It just came to me and I had to do it.
LOVE the moonshine barrel tank!!!
where'd ya get it?
Last edited:
- Status
Similar threads
